Chevrolet Cobalt Service & Repair Manual: Windshield Washer Fluid Reservoir, Replace
| 1. |
Disconnect washer hose clip at righthand
front fender flange. |
| 2. |
Disconnect washer pump hose from windshield
washer hose at righthand front fender flange. |
| 3. |
Remove righthand front fender liner
as outlined in "Front Fender Liner." |
| 4. |
Disconnect electrical connector from
windshield washer pump. |
| 5. |
Remove windshield washer fluid reservoir
nuts (1), Fig. 1. |
| 6. |
Lower and remove windshield washer
fluid reservoir (2) from righthand front engine rail and access
hole, Fig. 1. |
| 7. |
Open reservoir cap and pour windshield
washer solvent into a suitable clean container. |
| 8. |
Remove windshield washer pump, grommet
and reservoir cap and transfer to new component, as required. |
| 9. |
Reverse procedure to install. |
|
Fig. 1 Windshield washer fluid reservoir removal
1.
Drain washer solvent from windshield
washer fluid reservoir into suitable clean container.
2.
Remove front fender liner as outlined
...
Refer to Fig. 1
when performing following procedure.
1.
Remove instrument panel center trim
panel.
2.
Remove steering co ...
See also:
Chevrolet Cobalt Owners Manual. Rear Door Security Locks (Sedan)
Security Lock Label shown
The rear door security
locks are located on the
inside edge of each rear
door. You must open the
rear doors to access
them. The label showing
lock and unlock positions
is located near the lock.
To set the locks, do the following:
1. Insert the key into the secur ...
Chevrolet Cobalt Owners Manual
Chevrolet Cobalt Service Manual
Windshield Washer Fluid Pump, Replace
Windshield Washer Switch R&R