Chevrolet Cobalt Service & Repair Manual: Inspection

Chevrolet Cobalt Service & Repair Manual / Brakes / Drum Brakes / Inspection

Inspect components for damage or wear. Inspect wheel cylinder boots for tears, cuts or heat damage. Replace as required.

Remove wheel cylinder links. If fluid spills from boot center hole, replace wheel cylinder.

Brake Drums

Any time the brake drums are removed for brake service, the braking surface diameter should be inspected with suitable brake drum micrometer at several points to determine if they are within the safe oversize limit stamped on the brake drum outer surface. If the braking surface diameter exceeds specifications, the drum must be replaced. If the braking surface diameter is within specifications, drums should be cleaned and inspected for cracks, scores, deep grooves, taper, out-of-round and heat spotting. If drums are cracked or heat spotted, they must be replaced. Minor scores should be removed with sandpaper. Grooves and large scores can only be removed by machining with special equipment, as long as the braking surface is within specifications stamped on brake drum outer surface. Any brake drum sufficiently out-of-round to cause vehicle vibration or noise while braking or showing taper should also be machined, removing only enough stock to true up the brake drum.

After a brake drum is machined, wipe the braking surface diameter with a denatured alcohol soaked cloth. If one brake drum is machined, the other should also be machined to the same diameter to maintain equal braking forces.

Brake Linings & Springs

Inspect brake linings for excessive wear, damage, oil, grease or brake fluid contamination. If any of the these conditions exists, brake linings should be replaced. Do not attempt to replace only one set of brake shoes; they should be replaced as an axle set only to maintain equal braking forces. Examine brake shoe webbing, hold-down and return springs for signs of overheating indicated by a slight blue color. If any component exhibits overheating signs, replace hold-down and return springs with new ones. Overheated springs lose their pull and could cause brake linings to wear out prematurely. Inspect springs for sags, bends and external damage and replace as required.

Inspect hold-down retainers and pins for bends, rust and corrosion. If any of these are found, replace as required.

Backing Plate

Inspect backing plate shoe contact surface for grooves that may restrict shoe movement and cannot be removed by lightly sanding with emery cloth or other suitable abrasive. If backing plate exhibits these condition, it should be replaced. Also inspect for signs of cracks, warpage and excessive rust, indicating need for replacement. Inspect backing plate for evidence of axle seal leakage. Inspect backing plate mounting bolts and ensure they are tight.

Adjuster Mechanism

Inspect components for rust, corrosion, bends and fatigue. Replace as required. On adjuster mechanism equipped with adjuster cable, inspect cable for kinks, fraying or elongation of eyelet and replace as required.

Parking Brake Cable

Inspect parking brake cable end for kinks, fraying and elongation and replace as required. Use a small hose clamp to compress clamp where it enters backing plate to remove it.

Brake Service

Removal 1. Raise and support rear of vehicle, then remove tire and wheel assembly. 2. Mark drum and axle hub, then remove brake dr ...

Precautions

When working on or around brake assemblies, care must be taken to prevent breathing asbestos dust, as many manufacturers incorporate asbestos fibers in the production of brake linings. ...

Chevrolet Cobalt Service & Repair Manual: Inspection

Brake Service

Precautions

See also:

Chevrolet Cobalt Owners Manual

Chevrolet Cobalt Service Manual