Chevrolet Cobalt Service & Repair Manual: Rear Side Door
Removal
| 1. |
Disable Supplemental Inflatable Restraint
(SIR) system. |
| 2. |
Disconnect battery ground cable. |
| 3. |
Remove rear door trim panel. |
| 4. |
Remove water deflector. |
| 5. |
Remove rear side door check link bolt.
(2). |
| 6. |
Disconnect electrical connector, if
equipped. |
| 7. |
Support door before removing hinge
bolts (1) & (3), Fig. 1. |
| 8. |
With aid of an assistant, remove door. |
| 9. |
When replacing door it is required
to transfer all internal components. |
|
Installation
| 1. |
When replacing door it is required
to transfer all of internal components. |
| 2. |
With aid of assistant, support door
and carefully align hinges to hinge pillar. |
| 3. |
Install hinge to door frame bolts (1)
& (3), Fig. 1.Torqueto 26 ft. lbs. |
| 4. |
Connect electrical connector, if equipped. |
| 5. |
Install front side door check link
bolt (2). Torque to 15 ft. lbs. |
| 6. |
Install water deflector. |
| 7. |
Install front door trim panel. |
| 8. |
Connect battery ground cable. |
| 9. |
Enable Supplemental Inflatable Restraint
(SIR) system. |
|
Fig. 1 Rear side door
Removal
1.
Release lock rod using a flat-bladed
tool.
2.
Disconnect electrical connector if
equipped.
3.
...
Removal
1.
Remove interior trim panel.
2.
Remove water deflector.
3.
Remove rear side door lock screws (1),
...
See also:
Chevrolet Cobalt Service & Repair Manual. Pinpoint Test
Ensure battery voltage is greater
than 12 volts prior to and during pinpoint test.
Caution: Do not have a battery
charger attached during vehicle testing.
Warning: Never use electrical
test equipment on any circuit related to the SRS unless instructed by ...
Rear Compartment Lid Latch
Rear Side Door Latch