Chevrolet Cobalt Service & Repair Manual: Engine Oil Filter R & R
| 1. |
Raise and support the vehicle. |
| 2. |
Place a drain pan under the oil drain
plug. |
| 3. |
Remove the oil pan drain plug. |
| 4. |
Allow the oil to drain completely. |
| 5. |
Install the oil pan drain plug. |
| 6. |
Use tool No. J-44887 to loosen the
oil filter cap, Fig. 1. |
| 7. |
Remove the oil filter cap and filter. |
| 8. |
Remove the oil filter from the oil
filter cap, Fig. 2. |
| 9. |
Inspect the oil filter cap O-ring seal
for damage, replace as necessary. |
| 10. |
Reverse procedure to install, noting
the following: |
| |
a. |
Torque the plug to 18 ft. lbs. |
| |
b. |
Torque oil filter cap to 18
ft. lbs. |
|
Fig. 1 Oil filter cap replacement
Fig. 2 Oil filter replacement
Ground Cable
Battery To Battery Tray
Caution: Unless directed otherwise,
the ignition and start switch must be in the OFF or LOCK position, and all
electrical loads must be OFF before ...
Caution: Prolonged and repeated
contact with engine oil and grease will result in removal of natural oils
from skin, leading to dryness, irritation and dermatitis. In addition, used
...
See also:
Chevrolet Cobalt Owners Manual. Jump Starting
If the vehicle's battery has run down, you may want to
use another vehicle and some jumper cables to start
the vehicle. Be sure to use the following steps to do it
safely.
WARNING:
Batteries can hurt you. They can be dangerous
because:
- They contain acid that can burn you.
- They contain ga ...
Chevrolet Cobalt Owners Manual
Chevrolet Cobalt Service Manual
Battery Cable, Replace
Lube, Oil & Filter, Replace